RX 300 FWD V6-3.0L (1MZ-FE) (1999)
b. Remove these parts from the magnetic switch:
1. Starter housing and clutch assembly
2. Return spring
3. Idler gear
4. Bearing
4. REMOVE STEEL BALL
Using a magnetic finger, remove the steel ball from the clutch shaft hole.
5. REMOVE BRUSH HOLDER
a. Remove the 2 screws and end cover from the field frame.
Torque: 1.5 Nm (15 kgf.cm, 13 in.lbf)
b. Remove the O-ring from the field frame.
HINT: At the time of assembly, please refer to the following items. Use a new O-ring.
c. Using a screwdriver, hold the spring back and disconnect the brush from the brush holder.
Disconnect the 4 brushes, and remove the brush holder.