RX 300 FWD V6-3.0L (1MZ-FE) (1999)
Inscribed mark: A, B, C, D, E or F
4. INSPECT SPRING
Using a calipers, measure the free length of the spring.
Minimum free length: 32.3 mm (1.272 inch)
If it is not within the specification, replace the spring.
5. IF NECESSARY, REPLACE OIL SEAL
a. Using a screwdriver with vinyl tape wound around its tip, remove the oil seal.
NOTICE: Be careful not to damage the front housing.
b. Coat a new oil seal lip with power steering fluid.
c. Using SST, press in the oil seal.
SST 09950-60010 (09951-00330), 09950-70010(09951-07100)
NOTICE: Make sure to install the oil seal facing the correct direction.
REASSEMBLY
NOTICE: When using a vise, do not overtighten it.
1. COAT WITH POWER STEERING FLUID
2. INSTALL VANE PUMP SHAFT
3. INSTALL 2 STRAIGHT PINS
Using a plastic hammer, tap in 2 new pins.
NOTICE: Be careful not to damage the pins.