RX 300 FWD V6-3.0L (1MZ-FE) (1999)
Steering Gear: Service and Repair
Disassembly and Assembly
DISASSEMBLY
NOTICE: When using a vise, do not overtighten it.
1. REMOVE 2 TURN PRESSURE TUBES
a. Using SST, remove the tube.
SST 09633-00020
b. Remove the 2 O-rings from the tube.
2. SECURE PS GEAR ASSEMBLY IN VISE
Using SST, secure the gear assembly in a vise.
SST 09612-00012
3. REMOVE RH AND LH TIE ROD ENDS AND LOCK NUTS
a. Place matchmarks on the tie rod end and rack end.
b. Loosen the lock nut.
4. REMOVE RH AND LH CLIPS, RACK BOOTS AND CLAMPS
Using a screwdriver, loosen the clamp.
NOTICE:
-
Be careful not to damage the boot.
-
Mark the RH and LH boots.