RX 330 AWD V6-3.3L (3MZ-FE) (2004)
/Page-1697005.png)
G.
Proceed to the installation procedure for attaching the radiator grille.
Limited Edition RX 330 Grille Protector Installation:
1.
Use 3M(TM)GPAC or an equivalent cleaning agent to completely remove any dirt or contaminants left over from the double-sided tape where the
protector was installed.
Clean the protector in a well-ventilated location, away from any open flame.
2.
Peel back the backing paper on the double-sided tape on the protector (A) approximately 30 mm (1.18 in.).
3.
Align the center notch of the protector (A) to the upper center of the radiator grille, and then stick the protector to the grille starting from the center
of the protector (A).
4.
Press-fit the protector around the total circumference of the grille with a force of at least 9.8 N (1 kgf).
^
Attach the protector to the grille carefully, so that the protector is NOT misaligned or wrinkled.
^
When the temperature is at 59°F (15°C) or below, use a dryer to warm up the protector and the grille surface area where it adheres before fully
pressing down on the protector.
5.
Check that there is no gapping or peeling of the protector.
Attachment of the Radiator Grille:
