RX 330 AWD V6-3.3L (3MZ-FE) (2004)
/Page-1791005.png)
NOTE
In some instances, there may not be any slack.
17.
Install the NEW washers on the shafts and install the new motor/gearbox sub-assembly with the NEW hardware.
IMPORTANT
Proper torque is critical to component operation and longevity. Be sure to use an appropriate inch-pound torque wrench.
18.
Torque the 4 allen screws.
Torque: 4 N*m (41 kgf*cm, 35 in*lbf)
19.
Torque the 12-mm nuts.
Torque: 3.4 N*m (35 kgf*cm, 30 in*lbf)
20.
Remove the bolts holding the seat to the floor.
21.
Reassemble the remaining seat components in reverse order.
22.
Reinstall the seat to the floor and replace any garnishes removed.
Torque: 37 N*m (377 kgf*cm, 27 ft*lbf)
23.
Operate the seat several times to check for proper function and verify the noise is no longer present.
