RX 330 AWD V6-3.3L (3MZ-FE) (2004)
/Page-1133008.png)
a. Install the parking brake shoe assembly LH No.1 with the parking brake shoe hold down spring, parking brake shoe hold down spring cup
No.2, parking brake shoe hold down spring cup No.2 and parking brake shoe hold down spring pin No.1.
26. INSTALL PARKING BRAKE SHOE STRUT LH
a. Attach the parking brake shoe strut LH and the parking brake shoe strut compression spring to parking brake shoe assembly LH No.2 and
parking brake shoe assembly LH No.1.
27. INSTALL PARKING BRAKE SHOE RETURN TENSION SPRING
a. Using needle-nose pliers, install the 2 return tension springs No.1.
HINT: First install the front side spring then the rear side spring.
28. CHECK PARKING BRAKE INSTALLATION
a. Check that each part is installed properly.
NOTICE: There should be no oil or grease on the friction surface of the shoe lining and disc.
29. INSPECT BEARING BACKLASH (4WD DRIVE TYPE)
30. INSPECT AXLE HUB DEVIATION (4WD DRIVE TYPE)
31. INSTALL REAR DISC
a. Aligning the matchmarks, install the rear disc.
32. ADJUST PARKING BRAKE SHOE CLEARANCE
a. Temporarily install the hub nuts.
b. Remove the hole plug, turn the adjuster and expand the shoes until the disc locks.
c. Contract the shoe adjuster until the disc rotates smoothly.
