RX 330 AWD V6-3.3L (3MZ-FE) (2004)
b. Connect the vacuum hose to the brake booster assembly and slide the clip
25. INSTALL BRAKE TUBE
a. Install the 2 clearings of the brake tube to the body.
NOTICE: Be careful not to damage the brake tubes.
26. INSTALL WIRE HARNESS
a. Install the clip of the wire harness to the body.
b. Install the grommet of the wire harness to the body.
c. Install the bolt.
27. INSTALL BRAKE MASTER CYLINDER PUSH ROD CLEVIS
a. Install the push rod clevis and the push rod lock nut.
Torque: 26 Nm (265 kgf-cm, 19 ft. lbs.)
HINT: After adjusting the brake pedal height, torque the lock nut.
b. Apply lithium soap base glycol grease to the clevis pin.
c. Install the push rod pin and the clip.
28. INSTALL BRAKE PEDAL RETURN SPRING
a. Install the brake pedal return spring.
29. INSTALL COWL TOP PANEL SUB-ASSEMBLY OUTER
30. INSTALL FRONT SHOCK ABSORBER CAP RH (W/ AIR SUSPENSION)