RX 330 AWD V6-3.3L (3MZ-FE) (2004)
Wheel Speed Sensor: Service and Repair
Speed Sensor, Rear
SPEED SENSOR REAR LH
REPLACEMENT
HINT: Replace the RH side by using the same procedures as those for the LH side.
1. REMOVE REAR DOOR SCUFF PLATE LH
2. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH
3. REMOVE DECK BOARD SUB-ASSEMBLY
4. REMOVE REAR SEAT ASSEMBLY LH
5. REMOVE TONNEAU COVER ASSEMBLY
6. REMOVE DECK FLOOR BOX FRONT
7. REMOVE DECK FLOOR BOX REAR
8. REMOVE DECK BOARD SUB-ASSEMBLY NO.2
9. REMOVE DECK BOARD SUB-ASSEMBLY NO.3
10. REMOVE BACK DOOR WEATHERSTRIP
11. REMOVE DECK SIDE TRIM BOX LH
12. REMOVE REAR FLOOR FINISH PLATE
13. REMOVE REAR FLOOR FINISH SIDE PLATE LH
14. REMOVE DECK SIDE TRIM COVER LH
15. REMOVE REAR SEAT SIDE COVER LH
16. REMOVE ROPE HOOK
17. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH
18. REMOVE REAR WHEEL
19. REMOVE SPEED SENSOR REAR LH
a. Disconnect the speed sensor connector.
NOTICE: Be careful not to damage the wire harness.
b. Pull out the sensor wire harness with the grommet
NOTICE: Do not pull sensor wire.
c. Remove the 2 bolts holding the sensor harness from the body and the shock absorber assembly.