RX 330 AWD V6-3.3L (3MZ-FE) (2004)
a. Apply new engine oil to the thrust portion and journal of the camshaft.
b. Place the No 2 camshaft at a 90° angle of the timing mark (2 dot marks) on the cylinder head.
c. Apply MP grease to a new oil seal lip
d. Install the oil seal to the camshaft.
NOTICE:
^
Do not turn over the oil seal lip.
^
Insert the oil seal until it stops.
e. Remove any old packing material from the contact surface
f.
Apply seal packing to the No 1 bearing cap as shown in the illustration.
Seal packing: Part No. 08826-00080 or equivalent
NOTICE:
^
Install the No. 1 bearing cap within 5 minutes after applying seal packing.
^
Do not expose the seal to engine oil within 2 hours after installing.
g. Install the 5 bearing caps in their proper locations.
h. Apply a light coat of engine oil on the threads of the bearing cap bolts