RX 330 AWD V6-3.3L (3MZ-FE) (2004)
/Page-481011.png)
b. Jack up and slant the engine, and install the engine mounting bracket RH with the 2 bolts and nut.
Torque: 28 Nm (286 kgf-cm, 21 ft. lbs.)
c. Install the engine mounting insulator RH with the nut.
Torque: 95 Nm (969 kgf-cm, 70 ft. lbs.)
26. INSTALL TIMING BELT NO.2 COVER
a. Visually check for cracks and breaks on the gasket of the timing belt cover. If there is a trace that water is entering at the visual check, replace
the timing belt cover.
b. Install the timing belt cover.
Torque: 8.5 Nm (87 kgf-cm, 75 inch lbs.)
27. INSTALL TIMING BELT NO.1 COVER
a. Visually check for cracks and breaks on the gasket of the timing belt cover.
If there is a trace that water is entering at the visual check, replace the timing belt cover.
b. Install the timing belt cover.
Torque: 8.5 Nm (87 kgf-cm, 75 inch lbs.)
c. Install the engine wire protector cover to the timing belt No. 3 cover.
28. INSTALL CRANKSHAFT PULLEY
a. Align the keyway of the pulley with the key located on the crankshaft and slide the pulley into place.
b. Using SST, install the pulley bolt.
