RX 330 AWD V6-3.3L (3MZ-FE) (2004)
4. REMOVE FRONT FENDER TO COWL SIDE SEAL RH
5. REMOVE FRONT FENDER TO COWL SIDE SEAL LH
6. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSY
7. REMOVE WINDSHIELD WIPER LINK ASSY
8. REMOVE FRONT SHOCK ABSORBER CAP RH (W/ AIR SUSPENSION)
9. REMOVE FRONT SHOCK ABSORBER CAP LH (W/ AIR SUSPENSION)
10. REMOVE COWL TOP PANEL SUB-ASSY OUTER
a. Remove the clamp and disconnect the rubber grommet.
b. Remove the 4 bolts, 6 nuts and cowl top panel sub-assy outer.
11. DISCONNECT LIQUID TUBE SUB-ASSY A
a. Install SST(s) on piping clamp.
SST 09870-00025
HINT: Make sure the direction of the piping clamp claw and SST(s) by seeing the illustration shown on the caution label.
b. Push down SST(s) and release the clamp lock.
NOTE: Be careful not to deform the tube when pushing SST(s).
c. Pull SST(s) slightly and push the release lever, and then remove the piping clamp with SST(s).
d. Disconnect the liquid tube sub-assy A.
NOTE:
-
Do not use tools like screwdriver to remove the tube.
-
Cap the open fittings immediately to keep moisture or dirt out of the system.