RX 330 AWD V6-3.3L (3MZ-FE) (2004)
/Page-1447006.png)
-
The occupant classification ECU is replaced.
-
Accessories (seatback tray or seat cover, etc.) are installed to the vehicle.
-
The passenger seat is removed from the vehicle.
-
The SRS warning light comes on.
-
The vehicle is brought to the work shop for repair purpose due to the accident or collision.
VEHICLES NOT INVOLVED IN COLLISION
a. Do a diagnostic system check.
VEHICLE INVOLVED IN COLLISION
a. Do a diagnostic system check.
b. Do a visual check for damage to the occupant classification ECU, which includes the following items even if the airbag was not deployed:
-
Cracks, dents or chips in the case
-
Cracks, dents, chips and scratches in the connector
Rear Airbag Sensor
CAUTION: Be sure to perform the initialization of the occupant classification ECU under the conditions listed below.If the initialization is not
performed, the SRS may not operate properly.
-
The occupant classification ECU is replaced.
-
Accessories (seatback tray or seat cover, etc.) are installed to the vehicle.
-
The passenger seat is removed from the vehicle.
-
The SRS warning light comes on.
-
The vehicle is brought to the work shop for repair purpose due to the accident or collision.
VEHICLE NOT INVOLVED IN COLLISION
a. Do a diagnostic system check.
VEHICLE INVOLVED IN COLLISION AND AIRBAG IS NOT DEPLOYED
a. Do a diagnostic system check.
b. When the quarter panel of the vehicle or its periphery is damaged, check if there is any damage to the airbag sensor rear. if there are any defects as
mentioned below, replace the airbag sensor rear with a new one:
-
Cracks, dents or chips in the case
-
Cracks, dents, chips and scratches in the connector
-
Peeling off of the label or damage to the serial number
VEHICLE INVOLVED IN COLLISION AND AIRBAG IS DEPLOYED
a. Replace the airbag sensor rear.
Seat Position Airbag Sensor
CAUTION: Be sure to perform the initialization of the occupant classification ECU under the conditions listed below.If the initialization is not
performed, the SRS may not operate properly.
-
The occupant classification ECU is replaced.
-
Accessories (seatback tray or seat cover, etc.) are installed to the vehicle.
-
The passenger seat is removed from the vehicle.
-
The SRS warning light comes on.
-
The vehicle is brought to the work shop for repair purpose due to the accident or collision.
VEHICLES NOT INVOLVED IN COLLISION
a. Do a diagnostic system check.
VEHICLE INVOLVED IN COLLISION
a. Do a diagnostic system check.
b. Do a visual check for damage to the seat position airbag sensor, which includes the following items even if the airbag was not deployed:
-
Cracks, dents or chips in the case
-
Cracks, dents, chips and scratches in the connector
Side Airbag Sensor
CAUTION: Be sure to perform the initialization of the occupant classification ECU under the conditions listed below.If the initialization is not
performed, the SRS may not operate properly.
-
The occupant classification ECU is replaced.
-
Accessories (seatback tray or seat cover, etc.) are installed to the vehicle.
-
The passenger seat is removed from the vehicle.
-
The SRS warning light comes on.
