RX 330 AWD V6-3.3L (3MZ-FE) (2004)
/Page-1276002.png)
d. Torque the lock nut.
Torque: 56 Nm (570 kgf-cm, 41 ft. lbs.)
5. ADJUST TOE-IN (4WD DRIVE TYPE)
a. Measure the distance between each wheel disc and corner of the toe-adjusting cam, and then confirm that left and right distances are the same.
No. 2 lower suspension arm length difference: 1.0 mm (0.04 inch) or less
If the left-right difference is larger than 1.0 mm (0.04 inch), adjust it by following the procedures on the next page.
b. Turn the adjust cams by an equal amount to adjust toe-in.
HINT:
^
Try to adjust toe-in to the center value.
^
The toe-in will change by the following specifications corresponding to each graduation of the cam.
Approximately 3.3 mm (0.13 inch)
c. Tighten the nut.
Torque: 100 Nm (1,020 kgf-cm, 74 ft. lbs.)
6. INSPECT CAMBER
Air suspension
Coil suspension
HINT: Camber is not adjustable. If the measurement is not within the specification, inspect the suspension parts for damage and/or wear, and
replace them if necessary.
