RX 330 AWD V6-3.3L (3MZ-FE) (2004)
HINT: Separate the RH side using the same procedures as for the LH side
7. SEPARATE REAR SUSPENSION ARM ASSY NO.1 LH
a. Remove the bolt, nut and the rear suspension arm assy No.1 (outer side) from the rear axle carrier.
NOTICE: When removing the bolt, keep the nut from rotating.
8. SEPARATE REAR SUSPENSION ARM ASSY NO.1 RH
HINT: Separate the RH side using the same procedures as for the LH side.
9. REMOVE SPEED SENSOR REAR LH
10. REMOVE SPEED SENSOR REAR RH
HINT: Remove the RH side using the same procedures as for the LH side.
11. REMOVE REAR DRIVE SHAFT ASSY LH
12. REMOVE REAR DRIVE SHAFT ASSY RH
HINT: Remove the RH side using the same procedures as for the LH side.
13. REMOVE REAR SUSPENSION MEMBER SUB-ASSY
a. Support the rear suspension member with a jack.
b. Remove the 4 nuts, 2 bolts and 2 retainers from the rear suspension member.
c. Lower the rear suspension member.
14. REMOVE REAR SUSPENSION ARM ASSY NO.1 LH
a. Remove the bolt, nut and rear suspension arm assy No. 1.
NOTICE: When removing the bolt, keep the nut from rotating.
15. INSTALL REAR SUSPENSION ARM ASSY NO.1 LH