RX 330 AWD V6-3.3L (3MZ-FE) (2004)
/Page-1332016.png)
b. Place matchmarks on the adjust cams and rear suspension member sub-assy.
c. Remove the nut, camber adjust cam and toe adjust cam, and disconnect the rear suspension arm assy No.2 (inner side).
NOTICE: When removing the nut, keep the bolt from rotating.
d. Remove the bolt, nut and the rear suspension arm assy No.2 (outer side) from the rear axle carrier
NOTICE: When removing the bolt, keep the nut from rotating.
3. TEMPORARILY TIGHTEN REAR SUSPENSION ARM ASSY NO.2 LH
a. Install the rear suspension arm No.2 (inner side) to the rear suspension member sub-assy with the camber adjust cam and toe adjust cam, and
temporarily tighten the nut.
HINT: Ensure that the paint mark faces to the rear.
b. Connect the rear suspension arm assy No.2 (outer side) to the rear axle carrier with the bolt and nut.
NOTICE: When installing the bolt, tighten the bolt temporarily with the nut fixed.
4. STABILIZE SUSPENSION
5. FULLY TIGHTEN REAR SUSPENSION ARM ASSY NO.2 LH
