RX 330 AWD V6-3.3L (3MZ-FE) (2004)
15. DISCONNECT PRESSURE FEED TUBE ASSY
SST 09023-12700
16. REMOVE POWER STEERING LINK ASSY
17. REMOVE FRONT STABILIZER BAR BUSH NO.1
a. Remove the 2 bushes from the stabilizer
18. REMOVE MANIFOLD STAY
19. REMOVE EXHAUST MANIFOLD HEAT INSULATOR NO.1
20. REMOVE EXHAUST MANIFOLD CONVERTER SUB-ASSY
21. REMOVE STABILIZER BAR FRONT
a. Remove the stabilizer bar front from the vehicle.
22. INSTALL STABILIZER BAR FRONT
a. Install the stabilizer bar front from the vehicle.
23. INSTALL EXHAUST MANIFOLD CONVERTER SUB-ASSY
24. INSTALL EXHAUST MANIFOLD HEAT INSULATOR NO.1
25. INSTALL MANIFOLD STAY
26. INSTALL FRONT STABILIZER BAR BUSH NO.1
HINT: Install the bushing to the outer side of the bushing stopper on the stabilizer bar
27. INSTALL POWER STEERING LINK ASSY
28. INSTALL PRESSURE FEED TUBE ASSY
SST 09023-12700
29. INSTALL STEERING GEAR OUTLET RETURN TUBE
SST 09023-12700
30. CONNECT STEERING INTERMEDIATE SHAFT SUB-ASSY
31. INSTALL TIE ROD END SUB-ASSY LH
32. INSTALL TIE ROD END SUB-ASSY RH
HINT: Install the RH side following the same procedures as with the LH side
33. INSTALL FRONT STABILIZER BRACKET NO.2 LH
a. Install the front stabilizer bracket No.2from the stabilizer bar bush No.1.
34. INSTALL FRONT STABILIZER BRACKET NO.2 RH
HINT: Install the RH side following the same procedures as with the LH side
35. INSTALL FRONT STABILIZER BRACKET NO.1 LH
a. Install the 2 front stabilizer brackets No. 1 LH with the 2 bolts.
Torque: 16 Nm (163 kgf-cm, 12 ft. lbs.)
36. INSTALL FRONT STABILIZER BRACKET NO.1 RH
HINT: Install the RH side following the same procedures as with the LH side
37. INSTALL EXHAUST PIPE SUB-ASSY FRONT NO.3
38. INSTALL ENGINE UNDER COVER NO.2