RX 330 AWD V6-3.3L (3MZ-FE) (2004)
NOTICE: Do not use a punch for the marks.
e. Using a brass bar and hammer, remove the tripod joint from the outboard joint shaft.
NOTICE: Do not tap the roller.
21. REMOVE FRONT DRIVE SHAFT DAMPER LH
a. Using pliers, remove the drive shaft damper clamp, as shown in the illustration.
b. Remove the drive shaft damper.
22. REMOVE FRONT AXLE OUTBOARD JOINT BOOT LH NO.2 CLAMP
a. Using pliers, remove the outboard joint boot LH No.2 clamp, as shown in the illustration.
23. REMOVE FRONT AXLE OUTBOARD JOINT BOOT LH CLAMP
a. Remove the outboard joint boot LH clamp using the same procedures as for the outboard joint boot LH No.2 clamp.
24. REMOVE OUTBOARD JOINT BOOT
a. Remove the outboard joint boot from the outboard joint shaft.
b. Remove the old grease from the outboard joint.
25. REMOVE FRONT DRIVE INNER SHAFT INNER LH SHAFT SNAP RING (4WD, LH for 2WD DRIVE TYPE)
a. Using a screwdriver, remove the hole snap ring.
26. REMOVE FRONT DRIVE SHAFT DUST COVER LH
a. Using SST(s) and a press, remove the drive shaft dust cover LH.
SST 09950-00020