RX 330 AWD V6-3.3L (3MZ-FE) (2004)
B. Install the two (2) 0-rings to the RH bearing retainer.
NOTICE
Be careful NOT to twist the 0-ring and fit it into the retainer's groove properly.
6. Install the transfer RH bearing retainer sub-assembly.
A. Place the transfer case with the face where the RH bearing retainer is to be installed facing up as shown in the illustration.
B. Center-align the center differential control coupling assembly and the case.
C. Apply MP grease No.2 thinly to area A as shown in the illustration.
HINT