RX 350 AWD V6-3.5L (2GR-FE) (2007)
-
*4: To Rear Wheel Cylinder LH
-
*5: From 2nd Master Cylinder
-
*6: From 1st Master Cylinder
d. Pull the lock lever upward.
e. Disconnect the actuator connector.
f.
Remove the 2 bolts, the nut, and the brake actuator with brake actuator bracket.
NOTE: Be careful not to damage the brake tubes and wire harness.
5. REMOVE BRAKE ACTUATOR
a. Remove the 2 nuts and the brake actuator assembly from the brake actuator bracket.
INSTALLATION
1. INSTALL BRAKE ACTUATOR
a. Install the brake actuator to the actuator bracket assembly with the 2 nuts.
Torque: 5.4 N.m (55 kgf.cm, 48 in.lbf)
2. INSTALL BRAKE ACTUATOR WITH BRAKE ACTUATOR BRACKET
a. Install the brake actuator with brake actuator bracket with the 2 bolts and nut.
Torque: 19 N.m (194 kgf.cm, 14ft.lbf)
NOTE: Be careful not to damage the brake tubes and wire harness.