RX 350 AWD V6-3.5L (2GR-FE) (2007)
Bolt A 21 N*m (214 kgf*cm, 15 ft.*lbf)
Bolts B and C 9.1 N*m (93 kgf*cm, 81 in.*lbf)
NOTICE:
^
Make sure that there is no oil on the threads of bolts A.
^
Be sure to replace 2 bolts C with new ones or reuse them after applying adhesive 1344.
Adhesive: Toyota Genuine Seal Packing Black, Three Bond 1207B or Equivalent
2. INSTALL WATER INLET HOUSING
(a)
Install a new water inlet housing gasket and water outlet pipe O-ring.
(b) Install the water inlet housing with the 2 bolts and nut.
Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
NOTICE: Be careful not to allow the O-ring to get caught between the parts.
(c)
Connect the water hose.
3. INSTALL WATER PUMP PULLEY
(a)
Temporarily install the water pump pulley with the 4 bolts.
(b) Using SST, hold the water pump pulley.
SST 09960-10010 (09962-01000, 09963-00700)
(c)
Tighten the 4 bolts.
Torque: 21 N*m (214 kgf*cm, 15 ft.*lbf)
4. INSTALL V-RIBBED BELT TENSIONER ASSEMBLY