RX 350 AWD V6-3.5L (2GR-FE) (2007)
f.
Place the fuel delivery pipe and the 6 fuel injectors together to the intake manifold.
NOTE: Be careful not to drop the fuel injectors when installing the fuel delivery pipe.
g. Temporarily install the 5 bolts which are used to hold the fuel delivery pipe to the intake manifold.
NOTE: After installing the fuel injector, check that it turns smoothly. If not, reinstall it with a new O-ring.
h. Tighten the 5 bolts which are used to hold the fuel delivery pipe to the intake manifold.
Torque: 21 N.m (214 kgf.cm, 15 ft.lbf)
i.
Connect the 6 fuel injector connectors.
2. CONNECT FUEL TUBE SUB-ASSEMBLY
a. Push in the tube connector to the pipe until the tube connector makes a "click" sound.
NOTE:
-
Before connecting the tube, make sure that it is not damaged. Make sure that there is no dirt present on the connecting surfaces.
-
After connecting, check if the fuel tube connector and the pipe are securely connected by pulling on them.
b. Install the No. 2 fuel pipe clamp.
3. INSTALL INTAKE AIR SURGE TANK ASSEMBLY
4. INSTALL AIR CLEANER CAP SUB-ASSEMBLY
5. INSTALL COWL TOP PANEL OUTER SUB-ASSEMBLY
6. INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY
7. INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY
8. INSTALL FRONT FENDER TO COWL SIDE SEAL LH