Front Bumper Cover Gaps in RX 350 FWD V6-35L (2GR-FE) (2010)
from the vehicle's in-service date.
^ Warranty application is limited to occurrence of the specified condition described in this bulletin.
TSIB Overview
This TSIB provides an inspection and bumper retainer replacement procedure to correct excessive gaps at the corners of the front bumper.
Repair Procedure
1. Confirm that the front bumper cover is loose at either the left and/or right side corner(s) below the headlight assembly as shown in Figure 1.
A. If the front bumper cover is loose replace both retainer assemblies and proceed to step 2 of the removal procedure.
B. If the front bumper cover is NOT loose STOP This TSIB does NOT apply.
2. Remove the engine room side cover.
A. Remove the 4 clips.
B. Disengage the guide and remove the engine room side cover.
3. Remove the engine room side cover LH.