RX 350 FWD V6-3.5L (2GR-FE) (2010)
L. Remove the front bumper assembly as shown in Figure 14.
NOTE
To ensure the effectiveness of the repail; inspect the bumper cover mounting tabs for any damage or deformation.
7. Remove both the left and right side front bumper retainers and discard.
A. Remove the bolt and screw.
B. Disengage the 2 claws and remove the front bumper side retainer for both left and right side.
8. Cut the ridge from the forward clip on the NEW REPLACEMENT retainer as shown in Figures 16 and 17. Cut the shaded area with a knife so it is
even with the clip.
9. Install the NEW left and right side front bumper retainers.
A. Engage the 2 claws.
B. Install the bolt and screw.
10. Install the front bumper cover in the reverse order of removal.
For front bumper cover installation instructions refer to the Technical Information System (TIS) applicable model and model year Repair Manual:
^
2010 RX 350:
Vehicle Exterior - Exterior Panels/Trim - "Exterior Panels/Trim: Front Bumper: Installation"