RX 350 FWD V6-3.5L (2GR-FE) (2010)
Lower Side Moulding / Trim: Service and Repair
Installation
EXTERIOR PANELS / TRIM: SIDE MOULDING: INSTALLATION
1. INSTALL REAR DOOR OUTSIDE MOULDING SUB-ASSEMBLY
HINT
When installing the rear door outside moulding sub-assembly, heat the vehicle body and rear door outside moulding sub-assembly
using a heat light.
Heating Temperature
NOTICE:
Do not heat the vehicle body or moulding excessively.
(a) Clean the vehicle body surface.
(1) Using a heat light, heat the vehicle body surface.
(2) Remove the double-sided tape from the vehicle body.
(3) Wipe off any tape adhesive residue with cleaner.
(b) Clean the rear door outside moulding sub-assembly.
Standard Measurement
(1) Using a heat light, heat the rear door outside moulding sub-assembly.
(2) Remove the double-sided tape from the rear door outside moulding sub-assembly.
(3) Wipe off any tape adhesive residue with cleaner.
(4) Apply new double-sided tape to the rear door outside moulding sub-assembly.
(c) Install 8 new clips (quarter vent louver retainer) to the rear door outside moulding sub-assembly.
(d) Install the bolt to the rear door outside moulding sub-assembly.
(e) Install a new gasket to the bolt.
(f) Install the rear door outside moulding sub-assembly.