RX 350 FWD V6-3.5L (2GR-FE) (2010)
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
10. ADD ENGINE COOLANT See: Cooling System/Coolant/Service and Repair
11. INSPECT FOR ENGINE COOLANT LEAK See: Cooling System/Testing and Inspection
12. INSTALL V-BANK COVER SUB-ASSEMBLY See: Service and Repair/Removal and Replacement/Engine Assembly/Installation
13. INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY See: Brakes and Traction Control/Hydraulic System/Brake Master Cylinder/Service
and Repair/Removal and Replacement/Installation
14. INSTALL FRONT SHOCK ABSORBER CAP (w/ Air Suspension) See: Steering and Suspension/Suspension/Suspension Strut / Shock
Absorber/Service and Repair/Removal and Replacement/Front Shock Absorber (w/ Air Suspension)/Installation
15. INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY
(a) Install the windshield wiper motor and link assembly See: Wiper and Washer Systems/Wiper Motor/Service and Repair/Front Wiper
Motor/Installation.
16. INSTALL NO. 1 ENGINE UNDER COVER
From 08/2009
2GR-FE ENGINE CONTROL: IGNITION COIL AND SPARK PLUG: INSTALLATION
1. INSTALL SPARK PLUG
(a) Install the 6 spark plugs.
Torque : 18 Nm (184 kgf-cm, 13 ft-lbf)
2. INSTALL IGNITION COIL ASSEMBLY
(a) Install the 6 ignition coils with the 6 bolts.
Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)
(b) Connect the 6 ignition coil connectors.
(c) Connect the 3 wire harness clamps.