RX 350 FWD V6-3.5L (2GR-FE) (2010)
NOTICE:
*: Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the engine switch, any other
switches or the doors.
(a) If the result is not as specified, the DLC3 may have a malfunction. Repair or replace the harness and connector.
Electronic Circuit Inspection Procedure
INTRODUCTION: HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS: ELECTRONIC CIRCUIT INSPECTION PROCEDURE
1. BASIC INSPECTION
(a) WHEN MEASURING RESISTANCE OF ELECTRONIC PARTS
(1) Unless otherwise stated, all resistance measurements are standard values measured at an ambient temperature of 20°C (68°F). Resistance
measurements may be inaccurate if measured at high temperatures, i.e. immediately after the vehicle has been running. Measurements
should be made after the engine has cooled down.
(b) HANDLING CONNECTORS
Text in Illustration