RX 350 FWD V6-3.5L (2GR-FE) (2010)
(b) Using a screwdriver with the tip wrapped with protective tape, disconnect the 2 airbag connectors to remove the instrument panel wire
assembly from the front passenger airbag assembly.
Text in Illustration
NOTICE:
When disconnecting any airbag connector, take care not to damage the airbag wire harness.
From 08/2009
SUPPLEMENTAL RESTRAINT SYSTEMS: FRONT PASSENGER AIRBAG ASSEMBLY: REMOVAL
1. REMOVE NO. 1 CONSOLE BOX DUCT
HINT
Refer to the procedure up to Remove No. 1 Console Box Duct See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair/Removal and Replacement/Removal.
2. DISCONNECT INSTRUMENT PANEL WIRE ASSEMBLY
(a) Check that the engine switch is off.
(b) Check that the cable is disconnected from the negative (-) battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Slide the slider to release the lock, and then disconnect the connector.
Text in Illustration
NOTICE:
When disconnecting the airbag connector, take care not to damage the airbag wire harness.
3. REMOVE INSTRUMENT PANEL SAFETY PAD ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument
Panel/Service and Repair/Removal and Replacement/Removal
4. REMOVE FRONT PASSENGER AIRBAG ASSEMBLY