RX 350 FWD V6-3.5L (2GR-FE) (2010)
Seat Belt: Testing and Inspection
Front Seat Outer Belt Assembly
SEAT BELT: FRONT SEAT OUTER BELT ASSEMBLY: INSPECTION
1. INSPECT FRONT SEAT OUTER BELT ASSEMBLY
NOTICE:
Do not disassemble the retractor.
(a) Before installing the front seat outer belt assembly, check the ELR.
(1) When the inclination of the retractor is 15° or less, check that the belt can be pulled out from the retractor. When the inclination of the
retractor is over 45°, check that the belt locks.
If the result is not as specified, replace the front seat outer belt assembly.
(b) Check the tension reducer operation.
CAUTION:
Do not apply battery voltage to the pretensioner connector.
(1) Connect a positive (+) lead of the battery terminal 1 (IG) and a negative (-) lead to terminal 2 (L) of the tension reducer connector.
(2) Check that an operating sound is heard when the magnetized solenoid is attracting the plunger.
(3) Pull out the seat belt and let it retract. Listen to the operating sound.
(4) Pull out the seat belt again, disconnect the battery negative (-) lead and let it retract. Listen to the operating sound again and check that the
operating sound volume has increased.
If the result is not as specified, replace the outer belt assembly.