RX 350 FWD V6-3.5L (2GR-FE) (2010)
(d) Make sure that the clearance between the seat position sensor and seat rail is between 0.6 mm (0.0236 in.) and 2.0 mm (0.0787 in.).
(e) Connect the connector.
(f) Check that there is no looseness in the installation parts of the seat position sensor.
2. INSTALL FRONT SEAT ASSEMBLY LH See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Front Seat
Assembly/Installation
3. INSTALL REAR INNER SEAT TRACK BRACKET COVER LH See: Body and Frame/Seats/Service and Repair/Removal and
Replacement/Front Seat Assembly/Installation
4. INSTALL REAR OUTER SEAT TRACK BRACKET COVER LH See: Body and Frame/Seats/Service and Repair/Removal and
Replacement/Front Seat Assembly/Installation
5. INSTALL FRONT INNER SEAT TRACK BRACKET COVER LH See: Body and Frame/Seats/Service and Repair/Removal and
Replacement/Front Seat Assembly/Installation
6. INSTALL FRONT OUTER SEAT TRACK BRACKET COVER LH See: Body and Frame/Seats/Service and Repair/Removal and
Replacement/Front Seat Assembly/Installation
7. INSTALL FRONT SEAT HEADREST ASSEMBLY LH See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Front Seat
Assembly/Installation
8. INSPECT FRONT SEAT ASSEMBLY See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Front Seat
Assembly/Installation
9. PERFORM DIAGNOSTIC SYSTEM CHECK
(a) Perform a diagnostic system check See: Air Bag Systems/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/DTC
Check / Clear.
10. INSPECT SRS WARNING LIGHT
(a) Inspect the SRS warning light See: Air Bag Systems/Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnosis System.
From 08/2009
SUPPLEMENTAL RESTRAINT SYSTEMS: SEAT POSITION SENSOR: INSTALLATION
1. INSTALL SEAT POSITION SENSOR
(a) Install the seat position sensor to the seat slide position sensor protector with the pin as shown in the illustration.
(b) Using a 1.3 mm (0.0512 in.) feeler gauge, temporarily install the seat position sensor.