RX 350 FWD V6-3.5L (2GR-FE) (2010)
4. REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY
(a) Disconnect the connector.
(b) Remove the bolt and separate the height control sensor wire harness bracket.
(c) Remove the bolt and separate the height control sensor link from the rear upper control arm.
(d) Remove the 2 nuts and rear height control sensor sub-assembly from the rear suspension member.
NOTICE:
Do not drop the height control sensor. If it is dropped, replace it with a new one.
Up to 08/2009
SUSPENSION CONTROL: HEIGHT CONTROL SENSOR (for Rear Side): INSTALLATION
HINT
*
Use the same procedure for the RH side and LH side.
*
The procedure listed below is for the LH side.
1. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY
(a) Install the rear height control sensor sub-assembly with the 2 nuts.
Torque : 5.0 Nm (51 kgf-cm, 44 in-lbf)
NOTICE:
Do not drop the height control sensor. If it is dropped, replace it with a new one.
(b) Install the height control sensor link to the rear upper control arm with the bolt.