RX 350 FWD V6-3.5L (2GR-FE) (2010)
/Page-2321002.png)
NOTICE:
*
Be careful not to damage the tire pressure warning valve and transmitter due to interference between the valve and the tire bead.
*
Set the tire remover shoe as shown in the illustration.
Width (A):
10 to 20 mm (0.394 to 0.787 in.)
(d) Separate the upper bead.
(e) Take out the tire pressure warning valve and transmitter from the tire and separate the lower bead.
NOTICE:
Always use a new grommet, washer and nut when installing the tire pressure warning valve and transmitter.
From 08/2009
TIRE PRESSURE MONITORING: TIRE PRESSURE WARNING VALVE: REMOVAL
1. PRECAUTION (w/ Air Suspension)
NOTICE:
Be sure to read Precaution thoroughly before servicing See: Suspension/Service Precautions/Suspension Control System.
2. REMOVE FRONT WHEEL
3. REMOVE REAR WHEEL
4. REMOVE TIRE PRESSURE WARNING VALVE AND TRANSMITTER
(a) Remove the valve core and cap to release the air from the tire.
(b) After ensuring that a sufficient amount of air has been released, remove the nut and washer used to secure the tire pressure warning valve and
transmitter. Drop the tire pressure warning valve and transmitter into the tire.
HINT
Keep the removed cap and valve core.
(c) After dropping the tire pressure warning valve and transmitter into the tire, disengage the bead using the shoe of a tire remover.
Text in Illustration
NOTICE:
*
Be careful not to damage the tire pressure warning valve and transmitter due to interference between the valve and the tire bead.
*
Set the tire remover shoe as shown in the illustration.
Width (A):
