RX 350 FWD V6-3.5L (2GR-FE) (2010)
3. REMOVE FRONT AXLE INBOARD JOINT BOOT CLAMP
(a) Remove the front axle inboard joint boot clamp.
HINT
Perform the same procedure as for the No. 2 front axle inboard joint boot clamp.
4. SEPARATE FRONT AXLE INBOARD JOINT BOOT
(a) Separate the front axle inboard joint boot from the inboard joint assembly.
5. REMOVE FRONT DRIVE INBOARD JOINT ASSEMBLY
(a) Remove the grease from the inboard joint assembly.
(b) Put matchmarks on the inboard joint assembly and outboard joint shaft.
Text in Illustration
NOTICE:
Do not use a punch for the marks.
(c) Remove the inboard joint assembly from the outboard joint shaft.
(d) Using a snap ring expander, remove the shaft snap ring.
(e) Put matchmarks on the outboard joint shaft and tripod joint.
Text in Illustration