RX 400h AWD V6-3.3L (3MZ-FE) Hybrid (2007)
b. Fully insert a new gasket to the exhaust pipe center.
c. Using a plastic hammer, uniformly strike the gasket so that the gasket and front exhaust pipe center are properly fit.
NOTICE: Be careful with the installation direction of the gasket. Do not reuse the gasket. To ensure a proper seal, do not use the exhaust
pipe tail to press the gasket onto the exhaust pipe center.
d. Connect the exhaust pipe tail to the exhaust pipe supports.
e. Tighten the 2 bolts and 2 compression springs.
Torque: 48 Nm (490 kgf-cm, 35 ft. lbs.)
6. INSTALL OXYGEN SENSOR (for Bank 2)
7. INSTALL OXYGEN SENSOR (for Bank 1)
8. CHECK FOR EXHAUST GAS LEAKS
9. INSTALL ENGINE UNDER COVER NO. 2
10. INSTALL ENGINE UNDER COVER NO. 1