RX 400h AWD V6-3.3L (3MZ-FE) Hybrid (2007)
Front Airbag Sensor
ON-VEHICLE INSPECTION
1. INSPECT FRONT AIRBAG SENSOR (VEHICLE NOT INVOLVED IN COLLISION)
a. Perform a diagnostic system check.
2. INSPECT FRONT AIRBAG SENSOR (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS NOT DEPLOYED)
a. Perform a diagnostic system check.
b. When the front bumper of the vehicle or its area is damaged, check if there is any damage to the front airbag sensor. If any of the front airbag
sensor have defects as mentioned, replace it with a new one:
-
Cracks, dents or chips on the sensor housing.
-
Cracks or other damage to the connector.
-
Peeling off of the label or damage to the serial number.
CAUTION: Be sure to follow the correct removal and installation procedures.
3. INSPECT FRONT AIRBAG SENSOR (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS DEPLOYED)
a. Replace the front airbag sensor.
CAUTION: Be sure to follow the correct removal and installation procedures.
HINT: The front airbag sensor on the impacted side should be replaced after the steering pad, front passenger airbag assembly or driver side
knee airbag assembly has deployed.
Front Passenger Airbag Assembly
ON-VEHICLE INSPECTION
1. INSPECT FRONT PASSENGER AIRBAG ASSEMBLY (VEHICLE NOT INVOLVED IN COLLISION)
a. Perform a diagnostic system check.
b. With the front passenger airbag assembly installed on the vehicle, perform a visual check. If there are any defects as mentioned, replace the
instrument panel with a new one:
Cuts, minute cracks or marked discoloration on the instrument panel around the front passenger airbag assembly.
2. INSPECT FRONT PASSENGER AIRBAG ASSEMBLY (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS NOT DEPLOYED)
a. Perform a diagnostic system check.