RX 450h AWD V6-3.5L (2GR-FXE) Hybrid (2011)
NOTICE:
*
The power switch must be off.
*
Do not swap the DCM (Telematics Transceiver) with one from another vehicle.
NEXT -- PERFORM DCM ACTIVATION See: Scan Tool Testing and Procedures/DCM Activation
6. CHECK DTC
(a) Turn the power switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the power switch on (IG) and wait for 10 seconds.
(d) Turn the Techstream on.
(e) Perform "HEALTH CHECK" and check for current DTCs See: Initial Inspection and Diagnostic Overview/Safety Connect
System/Health Check.
Result:
B -- GO TO DIAGNOSTIC TROUBLE CODE CHART See: Powertrain Management/Computers and Control Systems/Testing and
Inspection/Diagnostic Trouble Code Descriptions/Safety Connect System
A -- Continue to next step.
7. REPLACE DCM (TELEMATICS TRANSCEIVER)
(a) Replace the DCM (Telematics Transceiver) See: Service and Repair/Removal.
NOTICE:
*
The power switch must be off.
*
Do not swap the DCM (Telematics Transceiver) with one from another vehicle.
NEXT -- PERFORM DCM ACTIVATION See: Scan Tool Testing and Procedures/DCM Activation
Red Indicator Remains On
CELLULAR COMMUNICATION: SAFETY CONNECT SYSTEM: RED INDICATOR REMAINS ON
- RED INDICATOR REMAINS ON
DESCRIPTION
When the red indicator remains on, this means that the DCM (Telematics Transceiver) has detected a malfunction in the Safety Connect system and set a
DTC.
INSPECTION PROCEDURE
PROCEDURE
1. CHECK DTC
(a) Turn the power switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the power switch on (IG) and wait for 10 seconds.
(d) Turn the Techstream on.