RX 450h AWD V6-3.5L (2GR-FXE) Hybrid (2011)
(b) Remove the bolt and screw.
(c) Disengage the claw, guide and remove the rear door window rear guide sub-assembly.
(d) Remove the temporary screw from the rear door window rear guide sub-assembly.
21. REMOVE REAR DOOR REAR GUIDE SEAL
(a) Remove the 2 screws and rear door rear guide seal.
22. REMOVE REAR DOOR GLASS SUB-ASSEMBLY
(a) Connect the cable to the negative (-) battery terminal and the rear power window regulator motor connector.
(b) Connect the power window regulator switch assembly and move the rear door glass sub-assembly so that the door glass bolts can be seen.
(1) w/ Navigation System for HDD:
NOTICE:
After the power switch is turned off, the display and navigation module display (HDD navigation system) records various types of
memory and settings. As a result, after turning the power switch off, make sure to wait at least 60 seconds before disconnecting the
cable from the negative (-) battery terminal.
(c) Disconnect the power window regulator switch assembly and rear power window regulator motor connector.
(d) Disconnect the cable from the negative (-) battery terminal.
CAUTION:
Wait for 90 seconds after disconnecting the terminal to prevent the airbag from deploying See: Restraint Systems/Air Bag
Systems/Service Precautions.
(e) Remove the 2 bolts.
NOTICE:
After the bolts are removed, do not allow the door glass to fall.
(f) Remove the rear door glass sub-assembly as indicated by the arrows in the order shown in the illustration.
NOTICE:
Do not damage the door glass.
23. REMOVE REAR DOOR WINDOW REGULATOR ASSEMBLY
(a) Loosen the temporary bolt.