RX 450h AWD V6-3.5L (2GR-FXE) Hybrid (2011)
(h) w/ Rain Sensor:
(1) Connect the No. 1 roof wire connector to the rain sensor.
(i) Connect the No. 2 antenna cord sub-assembly connectors and washer hose, and engage the 2 claws and 3 clamps to the rear pillar RH.
6. INSTALL ROOF HEADLINING ASSEMBLY (w/ Sliding Roof)
(a) Pull the roof headlining assembly into the vehicle through the back door.
NOTICE:
Do not damage the roof headlining assembly or body interior.
(b) Engage the 8 fasteners.
(c) Engage the 12 claws and 3 clips.
(d) Connect the No. 1 roof wire connector to the sliding roof drive gear assembly.
(e) Connect the No. 2 antenna cord sub-assembly connector and washer hose, and engage the 2 claws to the front pillar RH.
(f) w/o Manual (SOS) Switch:
(1) Connect the No. 1 roof wire connectors and engage the 2 claws to the front pillar LH.
(g) w/ Manual (SOS) Switch:
(1) Connect the No. 1 roof wire connectors and No. 5 antenna cord sub-assembly connector, engage the 2 claws to the front pillar LH.
(2) Connect the No. 5 antenna cord sub-assembly connector, engage the 2 claws and clamp to the rear pillar LH.