RX 450h AWD V6-3.5L (2GR-FXE) Hybrid (2011)
Electronic Brake Control Module: Service and Repair
Removal
BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: SKID CONTROL ECU: REMOVAL
NOTICE:
While the battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or
any door courtesy switch is turned on. Therefore, when servicing the brake system components, do not depress the brake pedal or
open/close the doors while the battery is connected.
1. PRECAUTION
CAUTION:
Be sure to read Precaution thoroughly before servicing See: Restraint Systems/Air Bag Systems/Service Precautions.
2. REMOVE FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY
HINT
Refer to the procedure up to Remove Front Passenger Side Knee Airbag Assembly See: Restraint Systems/Air Bag Systems/Air
Bag/Service and Repair/Removal and Replacement/Knee Airbag Assembly (for Front Passenger Side)/Removal.
3. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument
Panel/Service and Repair/Removal and Replacement/Removal
4. SEPARATE ECU INTEGRATION BOX RH
(a) Remove the 2 nuts and bolt, separate the ECU integration box RH.
5. SEPARATE CONNECTOR HOLDER
(a) Remove the nut and separate the connector holder.
6. REMOVE SKID CONTROL ECU
(a) Remove the 2 bolts and skid control ECU.
(b) Disconnect the 4 connectors from the skid control ECU.