RX 450h AWD V6-3.5L (2GR-FXE) Hybrid (2011)
NOTICE:
*
Prevent foreign matter from attaching to the rear speed sensor tip.
*
Clean the speed sensor installation hole and the contact surfaces every time the rear speed sensor is removed.
Installation
BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: REAR SPEED SENSOR (for AWD): INSTALLATION
HINT
If the sensor rotor needs to be replaced, replace it together with the rear axle hub and bearing assembly.
1. INSTALL REAR SPEED SENSOR LH
(a) Install the No. 1 bracket and rear speed sensor to the rear trailing arm assembly and the rear axle carrier sub-assembly with the 2 bolts.
Text in Illustration
Bolt A - Torque : 8.5 Nm (87 kgf-cm, 75 in-lbf)
Bolt B - Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)
NOTICE:
*
Prevent foreign matter from attaching to the rear speed sensor tip.
*
Clean the speed sensor installation hole and the contact surfaces every time the rear speed sensor is removed.
(b) Install the No. 3 bracket and No. 2 bracket to the upper control arm with the 2 bolts.
Text in Illustration
Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)