RX 450h AWD V6-3.5L (2GR-FXE) Hybrid (2011)
Bolt A - Torque : 21 Nm (214 kgf-cm, 15 ft-lbf)
Bolts B and C - Torque : 11 Nm (112 kgf-cm, 8 ft-lbf)
NOTICE:
*
Make sure that there is no oil on the threads of bolts A.
*
Be sure to replace 2 bolts C with new ones or reuse them after applying adhesive 1344.
Adhesive:
Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent
2. INSTALL WATER PUMP PULLEY
(a) Temporarily install the water pump pulley with the 4 bolts.
(b) Using SST, hold the water pump pulley.
SST : 09960-10010
09962-01000
09963-00700
(c) Tighten the 4 bolts.
Torque : 21 Nm (214 kgf-cm, 15 ft-lbf)
3. INSTALL WATER INLET HOUSING See: Engine/Service and Repair/Overhaul/Reassembly
4. INSTALL V-RIBBED BELT TENSIONER ASSEMBLY See: Engine/Service and Repair/Removal and Replacement/Engine Unit/Installation
5. INSTALL NO. 1 FRONT ENGINE MOUNTING BRACKET LH See: Engine/Service and Repair/Overhaul/Reassembly
6. INSTALL ENGINE HANGER See: Engine/Service and Repair/Removal and Replacement/Engine Unit/Installation
7. REMOVE ENGINE STAND See: Engine/Service and Repair/Removal and Replacement/Engine Unit/Installation
8. INSTALL HYBRID VEHICLE TRANSAXLE ASSEMBLY
HINT
See: Engine/Service and Repair/Removal and Replacement/Engine Assembly/Installation