RX 450h AWD V6-3.5L (2GR-FXE) Hybrid (2011)
ND-OIL 11 or equivalent
(c) Install the O-ring onto the discharge hose sub-assembly.
NOTICE:
*
Keep the O-ring and O-ring fitting surfaces free from dirt or any foreign objects.
*
Do not use any compressor oil other than ND-OIL 11 or equivalent. If any compressor oil other than ND-OIL 11 or equivalent is
used, compressor motor insulation performance may decrease, resulting in a leakage of electric power.
(d) Install the discharge hose sub-assembly onto the electric inverter compressor assembly with the bolt.
Torque : 9.8 Nm (100 kgf-cm, 87 in-lbf)
4. CONNECT SUCTION HOSE SUB-ASSEMBLY
(a) Remove the attached vinyl tape from the hose.
(b) Sufficiently apply compressor oil to a new O-ring and the fitting surface of the electric inverter compressor assembly.
Compressor oil:
ND-OIL 11 or equivalent
(c) Install the O-ring onto the suction hose sub-assembly.
NOTICE:
*
Keep the O-ring and O-ring fitting surfaces free from dirt or any foreign objects.
*
Do not use any compressor oil other than ND-OIL 11 or equivalent. If any compressor oil other than ND-OIL 11 or equivalent is
used, compressor motor insulation performance may decrease, resulting in a leakage of electric power.
(d) Install the suction hose sub-assembly onto the electric inverter compressor assembly with the bolt.
Torque : 9.8 Nm (100 kgf-cm, 87 in-lbf)
(e) Engage each clamp.
(f) Connect the connector [A] and lock the green-colored lock as shown in the illustration.