RX 450h AWD V6-3.5L (2GR-FXE) Hybrid (2011)
ND-OIL 11 or equivalent
(c) Install the O-ring on the air conditioning tube and accessory assembly.
NOTICE:
*
Keep the O-ring and O-ring fitting surfaces clean from dirt or any foreign objects.
*
Do not use any compressor oil other than ND-OIL 11 or equivalent. If any compressor oil other than ND-OIL 11 or equivalent is
used, compressor motor insulation performance may decrease, resulting in a leakage of electric power.
(d) Install the air conditioning tube and accessory assembly.
84. CONNECT SUCTION PIPE SUB-ASSEMBLY
(a) Remove the attached vinyl tape from the pipe.
(b) Sufficiently apply compressor oil to a new O-ring and the fitting surface of the suction pipe sub-assembly.
Compressor oil:
ND-OIL 11 or equivalent
(c) Install the O-ring on the suction pipe sub-assembly.
NOTICE:
*
Keep the O-ring and O-ring fitting surfaces clean from dirt or any foreign objects.
*
Do not use any compressor oil other than ND-OIL 11 or equivalent. If any compressor oil other than ND-OIL 11 or equivalent is
used, compressor motor insulation performance may decrease, resulting in a leakage of electric power.
(d) Install the suction pipe sub-assembly.
(e) Move the hook connector in the direction indicated by the arrow in the illustration.
(f) Insert the pipe joint into the fitting hole securely and tighten the bolt.
Torque : 9.8 Nm (100 kgf-cm, 87 in-lbf)
(g) Engage the 6 clamps to the engine wire harness.
85. INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY See: Brakes and Traction Control/Hydraulic System/Brake Master Cylinder/Service
and Repair/Removal and Replacement/Installation
86. INSTALL FRONT SHOCK ABSORBER CAP LH (w/ Air Suspension) See: Steering and Suspension/Suspension/Suspension Strut / Shock
Absorber/Service and Repair/Front Shock Absorber (w/ Air Suspension)/Installation
87. INSTALL FRONT SHOCK ABSORBER CAP RH (w/ Air Suspension)
HINT
Use the same procedure for the RH side and LH side.