RX 450h AWD V6-3.5L (2GR-FXE) Hybrid (2011)
(b) Disconnect the connector, and remove the bolt and electric vehicle battery plug.
Installation
HYBRID / BATTERY CONTROL: BATTERY PLUG: INSTALLATION
1. INSTALL ELECTRIC VEHICLE BATTERY PLUG ASSEMBLY
CAUTION:
Be sure to wear insulated gloves and protective goggles.
NOTICE:
*
Insulate the tool with insulating tape.
*
Do not use a universal joint. Using a universal joint may cause the socket extension to drop and create a short circuit.
(a) Install the electric vehicle battery plug with the bolt and connect the connector.
Torque : 7.5 Nm (76 kgf-cm, 66 in-lbf)
(b) Install the 2 nuts and connect the connector.
Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)
2. CHECK HIGH VOLTAGE CABLE CONNECTION See: Battery, Hybrid Drive/Service and Repair/Installation
3. INSTALL BATTERY COVER SUB-ASSEMBLY
HINT
See: Battery, Hybrid Drive/Service and Repair/Installation.
4. INSTALL SERVICE PLUG GRIP See: Service Plug Grip/Installation
5. INSTALL BATTERY SERVICE HOLE COVER See: Service Plug Grip/Installation
6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL