RX 450h AWD V6-3.5L (2GR-FXE) Hybrid (2011)
Body Control Module: Service and Repair
Removal
POWER DISTRIBUTION: MAIN BODY ECU: REMOVAL
1. REMOVE INSTRUMENT PANEL SAFETY PAD ASSEMBLY
HINT
Refer to the procedure up to Remove Instrument Panel Safety Pad Assembly See: Body and Frame/Interior Moulding /
Trim/Dashboard / Instrument Panel/Service and Repair/Removal and Replacement/Removal.
2. DISCONNECT DRIVER SIDE JUNCTION BLOCK ASSEMBLY
(a) Disconnect the 3 connectors.
(b) Disengage the 2 claws and disconnect the 2 connectors (1) as shown in the illustration.
(c) Disconnect the connector (2).
(d) Remove the bolt and nut, and disconnect the driver side junction block assembly.
(e) Disengage the claw and disconnect the connector as shown in the illustration.
(f) Disengage the 2 claws and release the connector lock as shown in the illustration.
(g) Disengage the claw and disconnect the connector as shown in the illustration.
(h) Remove the driver side junction block assembly.
3. REMOVE MULTIPLEX NETWORK BODY ECU
(a) Press the claw of the junction block as shown in the illustration to release the lock.