RX 450h AWD V6-3.5L (2GR-FXE) Hybrid (2011)
Camshaft Position Sensor: Service and Repair
Installation
2GR-FXE ENGINE CONTROL: CAMSHAFT POSITION SENSOR: INSTALLATION
1. INSTALL VVT SENSOR (for Bank 1)
(a) Apply a light coat of engine oil to the O-ring of the sensor.
(b) Install the sensor with the bolt.
NOTICE:
Make sure that the O-ring is not cracked or does not jump out of position during installation.
Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)
(c) Connect the sensor connector.
2. INSTALL VVT SENSOR (for Bank 2)
(a) Apply a light coat of engine oil to the O-ring of the sensor.
(b) Install the sensor with the bolt.
NOTICE:
Make sure that the O-ring is not cracked or does not jump out of position during installation.
Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)
(c) Connect the sensor connector.
3. INSTALL EGR DELIVERY CHAMBER See: Engine, Cooling and Exhaust/Engine/Intake Manifold/Service and Repair/Installation
4. INSTALL NO. 2 EGR PIPE See: Emission Control Systems/Exhaust Gas Recirculation/EGR Cooler/Service and Repair/Installation
5. INSTALL INTAKE AIR SURGE TANK ASSEMBLY See: Engine, Cooling and Exhaust/Engine/Intake Manifold/Service and
Repair/Installation
6. INSTALL AIR CLEANER ASSEMBLY See: Fuel Delivery and Air Induction/Throttle Body/Service and Repair/Installation
7. ADD ENGINE COOLANT (for Engine) See: Engine, Cooling and Exhaust/Cooling System/Coolant/Service and Repair/Coolant (for Engine)
8. INSPECT FOR COOLANT LEAK See: Engine, Cooling and Exhaust/Cooling System/Testing and Inspection/Component Tests and General
Diagnostics/Cooling System
9. INSPECT FOR OIL LEAK
(a) Start the engine, and check that there are no oil leaks.
10. INSTALL NO. 1 AIR CLEANER INLET See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine
Assembly/Installation