RX 450h AWD V6-3.5L (2GR-FXE) Hybrid (2011)
(e) Install the front No. 3 exhaust pipe sub-assembly with the 2 bolts and 2 compression springs.
Torque : 43 Nm (440 kgf-cm, 32 ft-lbf)
4. INSTALL OXYGEN SENSOR
(a) Using SST, install the oxygen sensor to the No. 3 front exhaust pipe sub-assembly.
Text in Illustration
SST : 09224-00010
without SST - Torque : 44 Nm (449 kgf-cm, 32 ft-lbf)
with SST - Torque : 40 Nm (408 kgf-cm, 30 ft-lbf)
NOTICE:
*
The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).
*
The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 300 mm (11.81 in.) See: Service
Precautions.
*
The "with SST" torque value is effective when SST is parallel to the torque wrench.
(b) Connect the wire harness clamp.
(c) Connect the 2 wire harness clamps and oxygen sensor connector.
5. INSPECT FOR EXHAUST GAS LEAK
6. INSTALL FRONT FLOOR COVER LH See: Engine, Cooling and Exhaust/Exhaust System/Exhaust Manifold/Service and Repair/Installation