RX 450h AWD V6-3.5L (2GR-FXE) Hybrid (2011)
2. INSTALL FRONT EXHAUST PIPE ASSEMBLY See: Engine, Cooling and Exhaust/Exhaust System/Exhaust Pipe/Service and
Repair/Installation
3. INSTALL NO. 3 FRONT EXHAUST PIPE SUB-ASSEMBLY
(a) Using a plastic hammer and wooden block, tap in a new gasket until its surface is flush with the No. 3 front exhaust pipe sub-assembly.
Text in Illustration
NOTICE:
*
Be sure to install the gasket in the correct orientation.
*
Do not reuse the gasket.
*
Do not damage the gasket.
*
Do not push in the gasket by using the exhaust pipe when connecting it.
(b) Install 2 new gaskets to the No. 3 front exhaust pipe sub-assembly.
(c) Install the No. 3 front exhaust pipe sub-assembly with the 2 bolts and 2 nuts.
Bolt - Torque : 55 Nm (561 kgf-cm, 40 ft-lbf)
Nut - Torque : 55 Nm (561 kgf-cm, 40 ft-lbf)
(d) Using a vernier caliper, measure the free length of the compression springs.
Minimum length:
41.5 mm (1.64 in.)
If the free length is less than the minimum, replace the compression spring.