RX 450h AWD V6-3.5L (2GR-FXE) Hybrid (2011)
Transmission Position Switch/Sensor: Service and Repair
Removal
P313 HYBRID TRANSMISSION / TRANSAXLE: SHIFT LEVER POSITION SENSOR: REMOVAL
1. PRECAUTION (w/ Air Suspension)
CAUTION:
Be sure to read Precaution thoroughly before servicing See: Steering and Suspension/Suspension/Service Precautions/Suspension
Control System.
2. REMOVE REAR DECK FLOOR BOX See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal and
Replacement/Removal
3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
4. REMOVE NO. 1 ENGINE UNDER COVER
5. SEPARATE TRANSMISSION CONTROL CABLE ASSEMBLY
(a) Remove the nut from the control shaft lever.
(b) Using a screwdriver, disengage the 2 claws and disconnect the control cable with clip from the control cable bracket.
(c) Remove the clip.
6. REMOVE SHIFT LEVER POSITION SENSOR
(a) Disconnect the shift lever position sensor connector.
(b) Remove the nut, washer and control shaft lever.
(c) Using a screwdriver, pry out the lock plate.