RX 450h AWD V6-3.5L (2GR-FXE) Hybrid (2011)
*
When deploying the airbag, perform the operation at least 10 m (32.8 ft.) away from the front passenger airbag assembly.
*
The front passenger airbag assembly becomes extremely hot when the airbag is deployed, so do not touch it for at least 30 minutes
after deployment.
*
Use gloves and safety glasses when handling a front passenger airbag assembly with a deployed airbag.
*
Do not apply water etc. to a front passenger airbag assembly with a deployed airbag.
*
Always wash your hands with water after completing the operation.
HINT
When scrapping a vehicle equipped with an SRS or disposing of the front passenger airbag assembly, be sure to deploy the airbag
first in accordance with the procedure described below. If any abnormality occurs with the airbag deployment, contact the Service
Dept. of TOYOTA MOTOR SALES, U.S.A., INC.
2. DISPOSE OF FRONT PASSENGER AIRBAG ASSEMBLY (When Installed in Vehicle)
NOTICE:
*
When disposing of the front passenger airbag assembly, never use the customer's vehicle to deploy the airbag.
*
Be sure to observe the following procedure when deploying the airbag.
HINT
Prepare a battery as the power source to deploy the airbag.
(a) Check the function of SST See: Steering Pad.
SST : 09082-00700
(b) Refer to Precaution See: Service Precautions.
(c) Disconnect the cable from the negative (-) battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(d) Remove the front passenger side knee airbag assembly See: Removal and Replacement/Knee Airbag Assembly (for Front Passenger
Side)/Removal.
(e) Remove the grove compartment door assembly See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Removal and Replacement/Removal.
(f) Disconnect the instrument panel wire assembly.
NOTICE:
When disconnecting any airbag connector, take care not to damage the airbag wire harness.
(1) Slide the slider to release the lock, and then disconnect the connector.
Text in Illustration