RX 450h AWD V6-3.5L (2GR-FXE) Hybrid (2011)
6. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal
and Replacement/Installation
7. INSTALL FRONT DOOR SCUFF PLATE LH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal and
Replacement/Installation
8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
9. INSTALL REAR DECK FLOOR BOX See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal and
Replacement/Installation
10. PERFORM DIAGNOSTIC SYSTEM CHECK
(a) Perform a diagnostic system check See: Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes.
11. INSPECT SRS WARNING LIGHT
(a) Inspect the SRS warning light See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnosis System.
12. INSPECT SUSPENSION CONTROL SYSTEM
(a) Inspect the suspension control system See: Steering and Suspension/Suspension/Suspension Control ( Automatic - Electronic )/Testing and
Inspection/Scan Tool Testing and Procedures/Test Mode Procedure.
Components
SUPPLEMENTAL RESTRAINT SYSTEMS: CURTAIN SHIELD AIRBAG ASSEMBLY: COMPONENTS
Removal
SUPPLEMENTAL RESTRAINT SYSTEMS: CURTAIN SHIELD AIRBAG ASSEMBLY: REMOVAL
HINT
*
Use the same procedure for the RH side and LH side.
*
The procedure listed below is for the LH side.
1. PRECAUTION
CAUTION:
Be sure to read Precaution thoroughly before servicing See: Service Precautions.
NOTICE: